Adjusting trunk lid - AR88.50-P-5200K
MODEL 208.3
| Adjusting in longitudinal direction | |||
| Risk of injury to fingers being jammed or squeezed when removing and installing or aligning hoods, doors, trunk lid/tailgate and sliding roof. | When moving components ensure that no body parts or limbs are in the area of motion. | AS00.00-Z-0011-01A | |
| 1 | Loosen screws (4) on hinge lever (3) on left and right | ||
| 2 | Loosen screws (2) on striker eye (1) | ||
| 3 | Adjust trunk lid so that rear edge of trunk lid is flush with rear fender and rear center section | Figure | |
| Gap dimensions on lids, doors and covers |
AR60.00-P-0700-01K | ||
| 4 | Loosen screws (4) on hinge lever (3) on left and right | *BA88.50-P-1001-01A | |
| Height adjustment | |||
| 5 | Adjust height of front edge of trunk lid on hinge levers so that outer edge of trunk lid is flush with fenders | Figure | |
Dimensions ↓ |
|||
| Adjust gap dimensions on hoods, doors and covers |
AR60.00-P-0700-01K | ||
| 6 | Press rear of trunk lid down until top edge of trunk lid is flush with rear fenders | See area D |
|
| N | Adjust trunk lid lock and striker eye | AR88.50-P-5020F | |
| Adjusting with eccentric bolt | |||
| 8 | Remove rear shelf | AR68.30-P-4580K | |
| 9 | Loosen nut (6) on eccentric bolt (7) | ||
| 10 | Adjust installation position of trunk lid with eccentric bolt (6) | ||
| 11 | Tighten nut (7) | *BA88.50-P-1003-01A | |
| 12 | Close trunk lid and check for proper functioning | ||
| 13 | Install rear shelf | AR68.30-P-4580K |
| Number | Designation | Model 208.3/4 | |
|---|---|---|---|
| BA88.50-P-1001-01A | Screw on trunk lid hinge on side wall | Nm | 10 |
| BA88.50-P-1003-01A | Nut on eccentric bolt | Nm | 25 |
Special tools