Removing and installing electronic ignition/starter switch control module - AR80.57-P-1000K

MODEL 208 

Fig 1: Identifying Electronic Ignition/Starter Switch Control Module Remove/Install Components

	Removal, installation
1	Remove bottom section of instrument panel (on driver-side)		AR68.10-P-1505K
2	Screw off round cover plate (1) with special tool		Fig 2
3	Pull electronic ignition switch control module (N73) toward rear out of cover below left side of instrument panel
4	Remove shift lock control cable (2) on electronic ignition switch control module (N73)	only on vehicles with automatic transmission
5	Disconnect electrical connectors (3) from electronic ignition switch control module (N73)	Use aid for connection and disconnection if required
6	Reinstall in opposite order	Installation:  When replacing electronic ignition switch control module (N73) program according to programming instructions included with programming station.

Fig 2: Identifying Claw-Type Wrench For Round Cover Plate On Ignition/Starter Switch (210 589 00 07 00)