Replacing rear crankshaft radial seal - AR03.20-P-3063RVK

ENGINE 113.990 in MODELS 211.076 /276 

ENGINE 113.991 in MODELS 215.374, 220.074 /174 

ENGINE 113.995 in MODEL 230.472 

Fig 1: Identifying Rear Crankshaft Radial Seal Remove/Install Components

	Remove/install
	Risk of death  caused by vehicle slipping or toppling off the lifting platform.	Align vehicle between columns of the lifting platform and position four support plates at the lifting platform support points specified by the vehicle manufacturer.	AS00.00-Z-0010-01A
1	Remove automatic transmission	Model 211	AR27.10-P-0500T
		Models 215, 220	AR27.10-P-0500I
		Model 230	AR27.10-P-0500R
2	Remove flywheel (3)	Models 211, 215, 220	AR03.30-P-8001C
		Model 230	AR03.30-P-8001RVK
3	Remove end cover (1).	Pry off end cover (1) carefully at both marked points with a slanted screwdriver (see arrows). Installation:  The crankshaft radial sealing ring (2) cannot be exchanged at end cover (1). This end cover (1) is fitted at the factory and therefore must be replaced.
			*BA01.40-P-1004-01C
4	Replace front crankshaft radial seal (2)	Installation:  Circumference and lip of crankshaft radial sealing ring (2) as well as counter contact surface on crankshaft must be free of oil and grease, in order to guarantee proper function.
		Notes on application of sealant to end cover with radial shaft seal Pay attention to fitted sleeves when pressing on end cover (1).	AH01.40-P-1000-06A
		Sealant	*BR00.45-Z-1013-01A
5	Install in the reverse order
	Risk of accident  caused by vehicle starting off by itself when engine is running. Risk of injury  caused by contusions and burns during starting procedure or when working near a running engine	Secure vehicle to prevent it from moving by itself. Wear closed and snug-fitting work clothes. Do not grasp hot or rotating parts.	AS00.00-Z-0005-01A
6	Carry out engine test run

CRANKCASE, TIMING CASE COVER, END COVER