Establishing/terminating a call, telephone, function - GF82.70-P-2008S
MODELS 215, 220 as of 1.6.04 with CODE (388) "Portable CTEL" UPCI telephone system
Function requirements:
- Voltage supply OK.
- MOST ring active.
- Portable CTEL (A34/6) inserted in the UHI Portable CTEL receiver (Universal Portable CTEL Interface) (A34/15).
- Enabled SIM card inserted into the portable CTEL (A34/6).
- Correct entry of PIN and successful log-in into the particular network of the service provider.
Placing a call
- After entering the desired telephone number or selecting a stored telephone number using the block of digits of the portable CTEL (A34/6) and subsequently operating the "Accept telephone call" button, the telephone call is being established.
- After entering the desired telephone number or selecting a stored telephone number via the block of digits of the COMAND operating, display and control unit (A40/3) with code (527) COMAND APS (with navigation) and subsequent operation of the "accept telephone call" button, the telephone call is being established.
- The multifunction steering wheel (MFL) can be used to select the telephone book via the system selection button (S110s3), and a stored telephone number can be selected using the scroll forward/back button (S110s1). The telephone call is then established via the "accept/terminate phone call" button (S111s3).
- After operating the VCS switch (S93/2) the telephone call can be established via voice input with code (813) voice control system (VCS).
With the Universal Portable CTEL Interface system (UPCI), all phone calls with the portable CTEL (A34/6) take place exclusively via the hands-free system.
The stored telephone numbers are either located on the SIM-card or in the memory of the telephone.
If an audio source (e.g. CD player with changer (in trunk) (A2/6)) is active at the time a telephone conversation starts, irrespective whether this is an incoming or outgoing telephone call, it is muted. During muting, the note "Telephone call" appears each time for instance in the display of the COMAND operating, display and control unit (A40/3) or in the multifunction display (A1p13) of the instrument cluster (A1).
Terminating a call
The user has several options for ending a telephone call:
- By pressing the "End telephone call" button at the portable CTEL (A34/6).
- By pressing the "End telephone call" button at the COMAND operating, display and control unit (A40/3) with code (527) COMAND APS (with navigation).
- By pressing the "accept/terminate telephone call" button (S111s3) at the multifunction steering wheel (MFL).
- With code (813) voice control system (VCS) through voice input, or by operating the VCS [SBS] switch (S93/2).
Only model 220
The rear telephone handset (A34/8) can be used to establish or terminate a telephone call via the Universal Portable CTEL Interface (UPCI) control unit (N123/1).
| Telephone antenna, location/task | GF82.62-P-4105S | ||
| Compensator, location/task | GF82.70-P-3109S | ||
| Hands-free microphone, location/task | GF82.70-P-4102SA | ||
| UHI Portable CTEL Receiver (Universal Portable CTEL Interface), location/task | GF82.70-P-5000S | ||
| Universal Portable CTEL Interface (UPCI [UHI]) control unit, location/task | GF82.70-P-5100S | ||
| Telephone/portable CTEL/STH radio remote control antenna splitter, location/task | GF82.70-P-5200S |