LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2001 >> CL55 >> Repair and Diagnosis >> Suspension >> Rear Suspension >> Rear Axle-- Testing & Repair -- 215 & 220 Chassis - 2 Of 2 >> Testing & Repair >> Remove/install inside CV joint or rubber boots on rear axle shaft - AR35.30-P-0660 >> Remove/install inside CV joint or rubber boots on rear axle shaft - AR35.30-P-0660I >> Caulk inner CV joint to rear-axle shaft - AR35.30-P-0660-04I

Caulk inner CV joint to rear-axle shaft - AR35.30-P-0660-04I

REFER TO SHOP-MADE TOOLS Shell halves (2 ea.) for pressing off and caulking the inner constant velocity joint. WF58.50-P-3530-01A
  1. Support inner constant velocity joint with the two shell halves (063a).
    Fig 1: Identifying Support Inner Constant Velocity Joint With Shell Halves (063A)
    G04845499
  2. Apply caulking (arrows) using a suitable cross-cut chisel (approx. 5 mm wide), whereby the material must "flow" into the groove in the rear-axle shaft.

    IMPORTANT The caulking must be applied to the land at an offset of 120°. It must not be applied in the vicinity of the narrow ball raceway.

    The caulking must be carried out such that the hub of the inner constant velocity joint can no longer be slid along the rear axle shaft.

    Fig 2: Identifying Support Inner Constant Velocity Joint
    G04845500
scientia non olet · About LEMON Manuals