Automatic one-touch up/down feature, function - GF72.29-P-3007S

MODEL 220 

Function prerequisites 

• Voltage not too low or too high and
• Circuit 15 ON or circuit 15R ON
• Power window synchronized 
• Function not disabled, version coding

Function 

The automatic one touch up/down feature is triggered by momentarily pressing the power window switch  past the first catch point in direction "close" or "open". The corresponding door control module (N69/1, N69/2, N69/3  orN69/4)  reads in the switch state and actuates the power window motor (M10/3, M10/4, M10/5  or M10/6  ) until it recognizes  via the position recognition  that the window is completely closed or open.

If the window is not synchronized  the manual opening/closing mode  is used instead of the automatic one touch up/down feature.

Function interruption 

The automatic one touch up/down feature is interrupted when

• the power window switch is actuated again or
• the pinch protection  is actuated as the window closes or
• the function prerequisites are no longer fulfilled.