Remove/install front center assembly suspension on rear axle carrier - AR35.10-P-0051I
MODEL 215.375 /378, 220.025 /026 /028 /063 /065 /067 /070 /075 /083 /084 /087 /126 /128 /165 /167 /170 /175 /178 /183 /184 /187
Fig 1: Identifying Front Center Assembly Suspension On Rear Axle Carrier Remove/Install Components - Model 215.375
| Remove/Install | |||
| Risk of death. Death may result if vehicle slips or topples off the lifting platform | Align vehicle between the columns of the lifting platform and position the four support plates at the lifting platform support points specified by the vehicle manufacturer. | AS00.00-Z-0010-01A | |
| While working on the rear axle care must be taken to ensure that the surface of all aluminum components do not get any scratches, cracks and notches. Otherwise the service life of the parts will be affected | |||
| Notes on self-locking nuts and bolts | AH00.00-N-0001-01A | ||
| 1 | Raise vehicle. | ||
| 2 | Use assembly attachment, pit hoist or floor jack to support rear axle center assembly. | Figure | |
| 3 | Unscrew bolt (51a) | ||
| *BA35.10-P-1002-04A | |||
| 4 | Remove washer (51b) | ||
| 5 | Unscrew nut (51c) | ||
| *BA35.10-P-1001-04A | |||
| 6 | Remove front rear axle center assembly suspension (51) | ||
| 7 | Install in the reverse order |
| Number | Designation | Model 215.373/ 375/378 | Models 220.025/026/ 028 /063/065/ 067/070/073/ 075/083/084/ 087/125/126/ 128/165/167/ 170/173/175/ 178/183/184/187 | ||
|---|---|---|---|---|---|
| BA35.10-P-1001-04A | Self-locking nut, front center assembly suspension to rear axle carrier | Nm | 120 | 120 | |
| BA35.10-P-1002-04A | Self-locking bolt, rear axle center assembly to front center assembly suspension | yellow | Nm | 45 | 45 |
| silver or blue | Nm | 60 | 60 | ||