Remove/install front seat cushion covering - AR91.18-P-1800MB

MODELS 220.0 /1 as of 1.9.02 with CODE (803) Model year 2003 

Fig 1: Identifying Front Seat Cushion Covering Remove/Install Components - Models 220.0 /1 As Of 1.9.02

	Remove/Install
1	Remove driver's seat cushion	Place driver's seat cushion on suitable surface with upholstery (1) facing downwards.	AR91.10-P-1070MB
2	Unhook covering (1) from clip groove around cushion frame (2).	Relieve seat cushion cover (1) tension by pressing cushion frame (2) down.
3	Remove cushion frame (2) from foam rubber padding (3)
4	Unhook three stapling clips (see arrows) from foam rubber padding (3) at each side	Pull upholstery (1) over outer edge of foam rubber padding (3).
5	Remove stapling clips (4, 11 pcs.) from stitching wires (5)	Do this by rotating stapling clips (4) 90° using flat nose pliers. Installation:  Use push-in tool.
	Installation tool for stitching wire		WF58.50-P-9118-02A
6	Remove upholstery (1) from foam rubber padding (3)	Installation:  Align upholstery (1) on foam rubber padding (3).
7.1	Pull stitching wire (5) out of material sleeves on upholstery (1)	Only when replacing upholstery (1).
8	Install in the reverse order