Install display instrument - AZ54.65-P-0001-05MS

203.2 

1. Connect connector of rear interior lamp to rear PTS warning indicator (A44/3) (see arrow).

   For this purpose loosen standard wiring harness from headliner.

2. Connect warning indicator wiring harness (1b) to 6-pin connector for rear PTS warning indicator (A44/3).
   Fig 1: Locating PTS Control Module And Sheet Metal Screw

   
3. Route warning indicator wiring harness (1b) from rear PTS warning indicator (A44/3) to ignition cartridge of left window airbag below headliner.

   Carefully route warning indicator wiring harness (1) in area of ignition cartridge as shown in figure section and fasten with felt strip. 

4. Route warning indicator wiring harness (1b) along left rear side window to taillamp and fasten to present wiring harnesses.
   Fig 2: Identifying Warning Indicator Wiring Harness In Area Of Ignition Cartridge

   
5. Route warning indicator wiring harness (1b) as shown in figure, route to rear warning indicator connector (X35/37) and fasten with felt strip.
   Fig 3: Identifying Warning Indicator Wiring Harness And Rear Warning Indicator Connector