Removing, installing rear seat belts - AR91.40-P-0681P

MODELS 203.0 /7

Shown for code (287a) through-loading feature Model 203.0

Fig 1: Identifying Rear Seat Belts Remove/Install Components - Shown For Code (287A) Through-Loading Feature Model 203.0

	Removing, installing
	The spring in the automatic belt retractors can pose an injury hazard when the tension is released and it uncoils.	Never dismantle automatic belt retractors	AS91.00-Z-0002-01A
1	Remove paneling on C-pillar	Model 203.0	AR68.30-P-4490P
		Model 203.7	AR68.30-P-4490PB
2	Unscrew screw (3) on belt guide (4)	Screw on rear belt guide	*BA91.40-P-1010-01A
		Torx bit set	Figure
3	Unscrew screw (2)	Screw on rear automatic belt retractor	*BA91.40-P-1006-01A
		Torx bit set	Figure
4	Remove automatic belt retractor (6)	If the seat belt with emergency belt tensioner has been replaced, the defective unit must be disposed of properly:
5	Install in the reverse order

SEAT BELTS/EMERGENCY BELT TENSIONERS

Number	Designation		Model 203
BA91.40-P-1006-01A	Screw to rear automatic belt retractor	Nm	30
BA91.40-P-1010-01A	Screw to rear belt guide	Nm	8

Fig 2: Identifying Torx Bit Set (000 589 01 10 00)