Remove and install injection valves - AR07.03-P-6522Q

ENGINE 271.940 in MODEL 203.042 /242 /742, 209.342 /442 

ENGINE 271.946 in MODEL 203.046 /246 /746 

ENGINE 271.948 in MODEL 203.040 /240 /740 

ENGINE 271.921 in MODEL 203.730 

ENGINE 271.955 in MODEL 209.341 /441 

Fig 1: Identifying Electrical Connector, Fuel Distributor, Anti-Twist Lock And Fuel Injection Valves - Engine 271

	Remove/Install
1	Open engine hood	Model 203	AR88.40-P-1000P
		Model 209	AR88.40-P-1000Q
2	Disconnect the electrical connectors (1) at the fuel injection valves (Y62)
3	Remove fuel distributor (2) together with the fuel injectors (Y62)		AR07.03-P-1450Q
4	Pull out anti-twist locks (3) at the fuel injectors (Y62)	Installation:  The anti-twist locks (3) must latch in at the fuel injectors (Y62).
5	Remove fuel injectors (Y62)	Inspect O-rings of the fuel injectors (Y62) and install new O-rings if necessary. Installation:  Lightly moisten O-rings with liquid lubricant.
		Lubricant	*BR00.45-Z-1002-06A
6	Install in the reverse order