CAN data bus, function - GF54.00-P-0005VA

MODEL 203 with ENGINE 272.920

MODEL 211 with ENGINE 272.922

MODEL 203, 209 with ENGINE 272.940

MODEL 203 with ENGINE 272.941

MODEL 171 with ENGINE 272.942

MODEL 211 with ENGINE 272.943

MODEL 211 with ENGINE 272.944

MODEL 251 with ENGINE 272.945

MODEL 221 with ENGINE 272.946

MODEL 203, 209 with ENGINE 272.960

MODEL 171 with ENGINE 272.963

MODEL 211, 219 with ENGINE 272.964

MODEL 221 with ENGINE 272.965

MODEL 230 with ENGINE 272.966

MODEL 164, 251 with ENGINE 272.967

MODEL 203 with ENGINE 272.970

MODEL 211 with ENGINE 272.972

MODEL 221 with ENGINE 272.975

MODEL 221 with ENGINE 273.922

MODEL 164 with ENGINE 273.923

MODEL 221 with ENGINE 273.924

MODEL 164 with ENGINE 273.943

MODEL 211, 219 with ENGINE 273.960

MODEL 216, 221 with ENGINE 273.961

MODEL 211 with ENGINE 273.962

MODEL 164, 251 with ENGINE 273.963

MODEL 230 with ENGINE 273.965

MODEL 209 with ENGINE 273.967

MODEL 221 with ENGINE 273.968

CAN stands for "C ontroller A rea N etwork". This is an electrical bus system for carrying data over two wires.

The tasks are:

Data exchange between the individual control units
Readying sensor signals for several systems
Reducing the number of wires
Improving the electromagnetic compatibility (EMC)

The CAN data bus consists of a special twisted two-core data line that connects all CAN users (control units) in parallel.

The two wires of the data line must not be mixed up (low level / high level). The motor electronics (N3/10) control unit is always a consumer with regard to bus adaptation.

A 120 Ω terminating resistor is therefore installed in the Motor electronics control unit.

The data are transmitted digitally over the CAN data bus at various intervals. The individual data blocks are defined in a data protocol and it is specified which data are received or transmitted by a control unit.

Each connected control unit is able to transmit or receive data (bidirectional data bus).

The sum of the data blocks, the short break between two transmission intervals and additional properties of the CAN data bus are checked constantly. Detected faults are stored and placed in the fault memory.

In the vehicle a distinction is made between the fast (500 kbit/s) engine compartment data bus and diagnostic CAN-data bus and the slower (83.3 kbit/s) interior CAN data buses.

The new control unit must be coded when a control unit is replaced.

This control unit coding takes place via a STAR DIAGNOSIS menu.

The international standardized network management "OSEK" (O pen systems and their I nterfaces for E lectronics in motor vehicles) is used for all control units of the CAN data bus.

ME-SFI [ME] control unit, component description

GF07.61-P-6000V