Jacking up and supporting vehicle - AR00.60-P-1000P
MODELS 203, 209.3 /4
| Fig. item etc. | Work instructions | ||
|---|---|---|---|
| Risk of death. Death may result if vehicle slips or topples from the lifting platform. | Align vehicle between the columns of the lifting platform and position the four support plates at the lifting platform support points specified by the vehicle manufacturer. | AS00.00-Z-0010-01A | |
| Risk of accident due to vehicle driving off on its own, when operating in the jacked-up state Risk of injury due to freely rotating parts when performing interventions during operations on the running engine or drive train | Ensure that supports are in a safe condition. An authorized person must occupy the driver's seat. Wear closed and snug-fitting work clothes. Do not grasp hot or rotating parts. |
AS00.00-Z-0008-01A | |
| To remove or install the underfloor paneling, the vehicle must be driven onto a drive-on lifting platform | |||
| If the lifting platform takeup points are not attached correctly to the lift support points (arrow) provided on the vehicle for this purpose, damage may be caused to the vehicle longitudinal supports | |||
| When removing the engine, the vehicle must be secured from tipping over or falling, where necessary | |||
| Jack up vehicle at front axle | AR00.60-P-1000-01P | ||
| Lifting platform | *WE58.40-Z-1001-05A |
WORKSHOP EQUIPMENT
| WE58.40-Z-1001-05A | Two-post lifting platform |