Removing and installing left rear seat backrest upholstery - AR91.18-P-1874PA

MODEL 203.2 /7 

Shown in model 203.2 

Fig 1: Identifying Left Rear Seat Backrest Upholstery Remove/Install Components - Shown In Model 203.2 (1 Of 2)

Shown in model 203.2 

Fig 2: Identifying Left Rear Seat Backrest Upholstery Remove/Install Components - Shown In Model 203.2 (2 Of 2)

	Removing, installing
1	Remove rear seat backrest (12)		AR91.12-P-1720PA
2	Set rear seat backrest (12) down on a suitable surface
3	Remove arm rest (13) from rear seat backrest	Model 203.2	AR91.12-P-1750PA
4	Unscrew bolts (15) from rear wall covering	Model 203.2
5	Remove rear wall covering (15)	Model 203.2
6	Remove arm rest recess covering (16)	Model 203.2
7	Remove cover from rear backrest release mechanism (17)
8	Remove head restraint guides (11)		AR91.16-P-1775P
9	Work the cover piece (10) for the safety belt loose	Model 203.2
10	Unscrew bolt from inner bearing bracket (2)		*BA91.12-P-1002-03C
11	Remove bearing bolt cover (7)	Unclip cover.
12	Remove loading compartment covering blind brackets (18)	Model 203.2
13	Dislodge the seat cover material (9) from the attachment groove running around the rear backrest frame
14	Remove felt covering (1)
15	Remove rear arm rest bracket	Model 203.2
16	Unhook seat covering material (9) from attachment groove running around rear backrest frame	Model 203.2
17	Unhook upholstery wire from rear backrest frame
18	Carefully pull out safety belt (19)	Model 203.2
19	Take off the seat cover (9) along with the foam padding (24)
20	Push seat covering (9) over foam rubber layer (24)
21	Disengage the clips (22) for length- and crosswise tightening by turning them 90°	Installation:  align clips (22) and attach to upholstery wires (23).
22	Pull upholstery wires (23) out of material sleeves	Installation:  insert and align upholstery wires (23)
23	Install in the reverse order

REAR SEATS

Number	Designation		Model 203
BA91.12-P-1002-03C	Bolt, inner bearing bracket to rear seat backrest	Nm	25