Removal & Installation
NOTE:
Letters and numbers in parenthesis correspond to letters and numbers in parenthesis in illustrations.
- Remove cover below instrument panel. See COVER BELOW INSTRUMENT PANEL .
- Unplug electric connector at brakelight switch (S9). See Fig 1 .
- Press locking device (S9b)
- Turn and pull out brakelight switch.
- Install disassembled components in reverse order.
- During installation, pullout actuating pin (S9a) completely, adjust if necessary. Push through brake pedal (24), insert brakelight switch and turn until locking device engages. The actuating path is adjusted automatically.