Install tailgate cover - AR72.20-P-3530-03PB
COMMERCIALLY AVAILABLE TOOLS
| Number |
Designation |
| WH58.30-Z-1002-20A |
Electric cartridge gun |
- Move nozzle along adhesive surface and apply glue.
Height of glue bead approx. 13 mm, in area of center high-mounted stop lamp only approx. 10 mm high.
Completely press out glue residues not required immediately following application (disposal).
- Position cover at top edge within 5 minutes and center.
Top edge of cover should be flush with body edge.
- Press on cover, adjust and fasten with adhesive tape.
- Screw on cover from inside with mounting screws (1).
The waiting time (time before vehicle is driven), is approx. 1 hour from the time the cover is installed.