Remove/install wind deflector - AR77.20-P-2500P

MODEL 203.0 /2 with CODE (414a) Glass electric tilting/sliding roof 

Shown on model 203.0 

Fig 1: Identifying Wind Deflector Remove/Install Components

	Remove/Install
1	Move tilting/sliding roof toward rear
2	Remove sealing rail (1)
3	Remove wind deflector (2)	Press wind deflector (2) on one side to inside with mounting wedge and simultaneously press lightly downward with thumb until height stop (4) is exposed. Do not break off retaining lug (5) Then turn wind deflector (2) slightly upward and unhook. Installation:  Ensure that leaf spring (3) is seated correctly on both sides.
		Mounting wedge	Figure
4	Install in the reverse order
5	Perform teach-in procedure for sliding roof obstruction sensor		AD00.00-P-2000-04A
		Diagnosis system STAR DIAGNOSIS	*WH58.30-Z-1048-13A

Fig 2: Identifying Mounting Wedge (110 589 03 59 00)