Removing and installing pressure connection at compressor - AR09.50-P-8831A

ENGINE 111.943 /944 /947 /973 /975 

Shown on model 111.975 

Fig 1: Identifying Pressure Connection Remove/Install Components - Shown On Model 111.975

	Removal, installation
1	Remove air cleaner	Disconnect suction and pressure pipe at compressor and seal openings at compressor	AR09.10-P-1050GA
2	Unbolt hose to intercooler at pressure connection	Seal off hose
3	Remove pressure connection (50/2)	Replace gasket
			*BA09.50-P-1005-01A
			*BA09.50-P-1006-01A
4.1	Remove hot water circulation pump	Only model 210
5	Install in the reverse order

Compressor

Number	Designation		Engine 111.943/944/947/973/975
BA09.50-P-1005-01A	Pressure connection to compressor	Nm	25
BA09.50-P-1006-01A	Connecting bolt of air intake/pressure connection	Nm	15