Drain/fill in coolant - AR20.00-P-1142SV
ENGINE 112.947 in MODEL 170.465
ENGINE 112.960 in MODEL 170.466
Shown on model 170.465
MODIFICATION NOTES
| 14.10.04 | Fill coolant using vacuum method added | Step 11 |
| Drain | |||
|---|---|---|---|
| Risk of injury to skin and eyes caused by scalding from contact with hot coolant spray. Risk of poisoning from swallowing coolant. | Do not open cooling system unless coolant temperature is below 90°C. Open cap slowly and release the pressure. Do not pour coolant into beverage containers. Wear protective gloves, protective clothing and safety glasses. |
AS20.00-Z-0001-01A | |
| Notes on coolant | AH20.00-N-2080-01A | ||
| 1 | Open engine hood | AR88.40-P-1000G | |
| 2.1 | Disconnect battery ground cable | Only when draining coolant at crankcase, right. |
AR54.10-P-0003A |
| 3 | Open cooling system cap (1) at coolant expansion reservoir (2) | ||
| 4 | Remove lower engine compartment paneling | AR61.20-P-1105A | |
| Drain coolant from radiator | |||
| 5 | Slide siphon hose onto fitting on radiator (3), open radiator drain plug (4) and drain coolant | ||
| 6 | Turn down radiator drain plug (4) and detach collector siphon hose from fitting at radiator (3). | ||
| Drain coolant at crankcase | |||
| 7 | Loosen crankcase drain plug (5) and push collector siphon hose onto crankcase drain plug (5). | ||
| 8 | Open the crankcase drain plug (5) and drain the coolant | ||
| 9 | Pull collector siphon hose off crankcase drain plug (5) and tighten crankcase drain plug (5). | *BA20.00-P-1001-02B | |
| 10 | Lower vehicle | ||
| Filling | |||
| 11 | Pour in coolant and bleed cooling system | AR20.00-P-1142-04A | |
| Figure | |||
| Figure | |||
| Coolant specifications | Sheet 310.1 | BB00.40-P-0310-01A | |
| Anticorrosion/antifreeze agents (Sheet 325.0) | Sheet 325.0 | BB00.40-P-0325-00A | |
| *BF20.00-P-1001-02K | |||
| Notes on coolant level | AH20.00-P-1142-01P | ||
| 12 | Inspect cooling system for leaks | AR20.00-P-1010P | |
| 13 | Install lower engine compartment paneling | AR61.20-P-1105A | |
| 14.1 | Connect ground cable to battery | Only when the coolant has been drained at the crankcase, right. | AR54.10-P-0003A |
| 15.1 | Perform basic programming | Only if the ground line of the battery has been disconnected. | AR00.19-P-0200B |
| 16.1 | Connect up STAR DIAGNOSIS, read and erase diagnostic trouble code memory | Only if the ground line of the battery has been disconnected. | |
| Connect up STAR DIAGNOSIS and read out fault memory | AD00.00-P-2000-04A | ||
| STAR DIAGNOSIS diagnosis system | *WH58.30-Z-1048-13A | ||
| 17 | Close engine hood | AR88.40-P-1000G |
| Number | Designation | Engines 112, 113.940/941/ 942/943/944/ 945/946/948/ 960/961/963/ 964/965/966/ 967/968/971/ 980/981/984/ 986/987/988/ 990/991/992/ 955 | |
|---|---|---|---|
| BA20.00-P-1001-02B | Coolant drain plug to crankcase | Nm | 12 |
| Number | Designation | Engine 112 in model 170 | ||
|---|---|---|---|---|
| BF20.00-P-1001-02K | Cooling system | Total filling capacity | Liters | ≈ 8 |
| Capacity of anticorrosion/antifreeze agent down to -37°C | Liters | ≈ 4 | ||
| Filling capacity of anticorrosion/antifreeze down to -45°C | Liters | ≈ 4.5 | ||
| Specifications for Operating Fluids | Sheet | BB00.40-P-0310-01A | ||
| Sheet | BB00.40-P-0325-00A | |||
COMMERCIALLY AVAILABLE TOOLS
| Number | Designation | |
|---|---|---|
| WH58.30-Z-1048-13A | STAR DIAGNOSIS diagnosis system, Compact Passenger Car | 6511 1801 00 |