Removing and installing paneling on A-pillar - AR68.30-P-4050G
MODEL 170
| Removal | |||
|---|---|---|---|
| 1 | Remove paneling at top of windshield | AR68.30-P-4250G | |
| 2 | Press paneling (1) out of retaining clips (3 each) with installation wedge (arrow) starting at top retaining clip | Figure | |
| 3 | Remove paneling (1) toward middle of vehicle | ||
| Installation | |||
| 4 | Install retaining clips (4, 3 each) on A-pillar and attach electric wire | ||
| 5 | Position paneling (1) flush on top section of instrument panel and press into retaining clips (4 and 5) | ||
| 6 | Install paneling at top of windshield | AR68.30-P-4250G | |
| 7 | Lift rubber lip on A-pillar seal (arrows) over panels (1 and 2) | Figure |