Retrofitting global positioning system (GPS) antenna - AN82.61-P-7474-04X

Model 170 

1. Mask trunk lid from outside over large surface with masking tape or foil.
2. Mark centering hole in middle of inside of trunk lid as shown in figure.
3. Cut antenna hole to 15 mm dia.
   Fig 1: Identifying Antenna Hole

   
4. Install antenna (A2/23) in trunk lid, align according to vehicle longitudinal direction (arrow) and press on lightly to trunk lid.

   The hole pattern for the front locating pin of the antenna will be marked on the gluing surface.

   Fig 2: Identifying Antenna Trunk Lid

   
5. Mark hole for locating pin and drill with 3.5 mm dia. bit.

   When cutting the holes do not damage paint and trunk lid. Do not remove drilling chips with magnet. Coat bare points on body at holes with primer.

   Fig 3: Identifying Antenna Hole Dimension

   
6. Pull adhesive foil off of antenna base.
7. Install antenna and align.
8. Screw on antenna from inside.
9. Connect antenna extension lead to antenna.

   Fasten antenna lead in trunk lid with adhesive felt.

   Fig 4: Identifying Antenna Screw

   
10. Connect antenna extension lead (11) to antenna.
11. Fasten connector (12) in trunk lid with felt strips.
12. Fasten lead (11) with cable straps (arrow).
    Fig 5: Identifying Wire Route