Test program - ASR II electrics/electronics - RA42001400822X(42-0822)

Conditions for test

Connect bridges 1 ↔ 11 and 10 ↔ 34 to socket box for the complete ASR test program.
For all test steps with ignition: ON , LED must come on, i.e. battery voltage in order.
Only take note of ABS and ASR warning lamps and ASR function indicator lamp for test work in which these lamps are listed in the nominal value section.
Perform test steps 39 and 40 in sequence.
Correct fluid level in brake fluid reservoir after test step 40 (accumulator full).
The vehicle must not be driven with the ABS adapter connected.

NOTE: For electrical wiring diagrams and position of the plug connections, refer to "Electrical wiring diagrams - passenger cars - volume 2 or volume 4" and "Electrical wiring diagrams model 129 volume 1".

Special tools

Fig 1: Identifying Special Tools (129 589 00 21 00 54)

Fig 2: Identifying Special Tools (126 589 09 21 00 42)

Fig 3: Identifying Special Tools (645 589 00 63 00 42 54)

Fig 4: Identifying Special Tools (645 589 01 63 00 42 54)

Fig 5: Identifying Special Tools (645 589 02 63 00)

Fig 6: Identifying Special Tools (201 589 00 99 00 15 54)

NOTE: The lug (arrow) must be sawn off on test cable 645 589 02 63 00.

Fig 7: Locating Lug

COMMERCIALLY AVAILABLE TOOL OR TESTERS

Designation	e.g. Company, order no.
Multimeter	Sun, DMM-5

Clarification of

	Socket box
	Multimeter
	Voltage measurement (volts, direct current).
	Voltage measurement (volts, alternating current)
	Resistance measurement (ohm)
	Bridge
	Socket
	Pin