Display in instrument cluster indicates "Pneumatic suspension ... Visit workshop" (C1121, C1122, C1123, C1132, C1133)- AF32.32-P-2010A

MODEL 220 

MODIFICATION NOTES

1.2.01

Replaces STIP no. 32.32-005 dated 1.4.99

Remedy changed

Damage code	Cause	Remedy
32 547 47 32 548 37	Water entry at lever sensor plug	1 Disconnect plug contact from lever sensor and check Ensure that a blind plug is present all chambers to which lines are not connected.
	In this case, the following DTC's are stored in the pneumatic suspension DTC memory (some/all): C1121 Fault in component B24/3 (front left body lateral acceleration sensor) C1122 Fault in component B24/4 (front right body lateral acceleration sensor) C1123 Fault in component B24/6 (rear right body lateral acceleration sensor) C1132 Fault in component B22/8 (front left level sensor) C1133 Fault in component B22/9 (front right level sensor) C1135 Fault in component B22/3 (rear right level sensor) C1144 Fault in component B7 (air suspension pressure sensor)	No blind plug presence ↓ 2.1 Insert blind plug and clean connector When reconnecting ensure that no moisture is present in plug One sensor failure in spite of blind plugs presence ↓ 3 Replace sensor

PARTS ORDERING NOTES

Part no.	Designation	Quantity
000 545 87 80	Blind plug	as required