Remove/Install Charge Air Duct Downstream Of Charge Air Cooler - Ar09.50-P-8680H

Engine 275 In Model 215, 216, 220, 221, 230

Engine 285 In Model 240

Illustrated On Model 240

Fig 1: Identifying Charge Air Duct Downstream Remove/Install Components

G04840101

	Remove/install
1	Remove air filter housing	Model 215, 216, 220, 221, 230	AR09.10-P-1150LA
		Model 240	AR09.10-P-1150H
2	Release hose clamps (1) on charge air hoses (2)	Tighten hose clamps (1) using the prescribed torque so that charge air cooler (6) can separate from charge air ducts in the event of an accident.
			*BA09.41-P-1002-02B
3	Release hose clamps (3) on charge air duct (4)	Tighten hose clamps (3) using the prescribed torque so that charge air cooler (6) can separate from charge air ducts (4) in the event of an accident.
			*BA09.41-P-1003-02B
4	Remove screws (5)	Do not open the low temperature water circuit.
			*BA09.41-P-1001-01G
5	Lever charge air cooler (6) out of charge air hoses (2)	Do not damage coolant hoses running to charge air coolers (6).
6	Take charge air cooler (6) out of charge air duct (4)
7	Remove charge air duct (4) from throttle valve actuator (M16/6) and take it out
8	Install in the reverse order

TORQUE SPECIFICATION

Charge Air Duct

Number	Designation		Engine 275, 285
BA09.41-P-1002-02B	Hose clamp, charge air hose to engine charge air channel and to charge air cooler	Nm	3
BA09.41-P-1003-02B	Hose clamp, charge air channel as required charge air cooler to charge air cooler and to electronic accelerator actuator	Nm	3

TORQUE SPECIFICATION

Charge Air Pipe/Charge Air Cooling

Number	Designation		Engine 275, 285
BA09.41-P-1001-01G	Bolt, charge air cooler to cylinder head cover	Nm	8