Adjusting parking brake - AR42.20-P-0540I

MODELS 215, 220 (except 215.379, 220.179) 

Fig 1: Identifying Adjusting Wheel

	Adjust
	Risk of death  cased by vehicle slipping or toppling off of the lifting platform.	Align vehicle between the columns of the hydraulic hoist and position the four support plates below the hoist support points specified by the vehicle manufacturer.	AS00.00-Z-0010-01A
	Notes on repairs to brake system	All models	AH42.00-P-0003-01A
1	Check version of parking brake pedal assembly
	Parking brake pedal assembly modified		BT42.20-P-0510-01A
2	Operate parking brake pedal and check pedal travel of parking brake pedal	If the pedal travel is not within the tolerance range, adjust parking brake.
		Actuating force on parking brake pedal	*BE42.20-P-1001-01C
		Notches through which the parking brake pedal must be depressed	*BE42.20-P-1002-01C
3	Lift vehicle with lifting platform until the wheels are clear
4	Pre-tension automatic cable slack adjuster		AR42.20-P-0520-01A
5	Remove rear wheels.
	Remove/install wheels, rotate if necessary		AP40.10-P-4050Z
6	Using a suitable tool, turn the adjusting wheel (105) until the brake shoes touch the brake drum and the rear wheel no longer turns	Adjustment direction for applying the brake shoes: Right side: Turn the adjusting wheel (105) from the bottom upwards. Left side: Turn the adjusting wheel (105) from the bottom upwards.
7	Turn back the adjusting wheel (105) until the rear wheel can be turned completely freely	When slackening the adjusting wheels ensure that both sides are turned back by the same number of teeth (10 teeth).
8	Relieve load on automatic cable slack adjuster.		AR42.20-P-0520-02A
9	Actuate parking brake pedal several times	Actuating force on parking brake pedal	*BE42.20-P-1001-01C
		Notches through which the parking brake pedal must be depressed	*BE42.20-P-1002-01C
10	Check that the rear wheels can turn freely
11	Mount rear wheels
	Remove/install wheels, rotate if necessary		AP40.10-P-4050Z