Stationary heater starts without cause and/or indicator lamp flashes - AF82.85-P-6008A

MODEL 215, 220 with CODE (228) Stationary heater with CODE (352) COMAND operating and display system

MODIFICATION NOTES

10.9.01

Supercedes STIP 83.70-026 dated 07.09.2001

OPERATION NO. OF OPERATION TEXTS OR STANDARD TEXTS AND FLAT RATES

Category	Op. no.	Operation text	Time	Acc. no.	Code
P	541011	CONNECT STAR DIAGNOSIS	004 WU/0.3 h	-	-
P	541035	RECODE CONTROL UNITS AFTER CHECKING	002 WU/0.2 h	-	-

Damage code	Cause	Remedy
	Instrument cluster coding	Recode COMAND in instrument cluster:↓
	On vehicles with special equipment stationary heater code 228 and COMAND code 352 it can occur in individual cases that the stationary heater starts up apparent cause or that the yellow indicator lamp in the stationary heater (S46) starts flashing. Time setting has not been programmed.	1 Connect STAR DIAGNOSIS.
		2 Select corresponding vehicle model.
		3 Select "Control units".
		4 Select "Information and communication".
		5 Select "KIW instrument cluster with maintenance interval"
		6 Select "Control unit adaptation".
		7 Select "Standard version coding".
		8 Read coding and erase if necessary.
		9 Select "Special equipment"
		10 Select "COMAND operating and display system".
		11 Set "COMAND" to not present.
		12 Transmit coding, confirm with F3.
		13 Select "Operating and display system".
		14 Set "COMAND" to present.
		15 Transmit coding, confirm with F3.
		16 End STAR DIAGNOSIS session.