Fault message in instrument cluster (IC) "Check left low beam bulb" - AF82.10-P-8002A

MODEL 220, 215 with xenon headlamp or bi-xenon headlamp 

OPERATION NO. OF OPERATION TEXTS OR STANDARD TEXTS AND FLAT RATES

Category	Op. no.	Operation text	Time	Acc. no.	Code
P	541011	Perform quick test	004 WU	-	-
P	821201	Replace defective bulb on one lamp of exterior lighting	002 WU	-	-

Damage code	Cause	Remedy
	Warning message in instrument cluster "Check left low beam bulb"	1 Perform short test with STAR DIAGNOSIS.
	The DTC B1630 is stored in the right SAM control unit. However, low beam is okay.	The fault B1630 is stored in the right SAM control unit, however the low beam is okay.
	In individual cases the xenon burner may not ignite during the first ignition attempt due to tolerances of the ignition voltage.	2 Remove/install/replace the front left xenon burner. Use only the part numbers listed below. The new xenon burners are from Messrs Philips. In the case of complaints do not use Osram xenon burners for models 215 and 220. The optimized xenon burners were added as replacement parts with index 07. The ignition voltage tolerances of the xenon burner were optimized. New xenon burners: Model 220 before model refinement (before VIN end number 316 717) N 910 139 000 000 07 Model 220 as of model refinement (clear glass headlamps) N 910 139 000 001 07 Model 215 N 910 139 000 001 07
		3 Erase fault memory.

PARTS ORDERING NOTES

Part no.	Designation	Quantity
N 910 139 000 000 07	Xenon burner D2R (Messrs Philips for headlamps with reflection system)	As required
N 910 139 000 001 07	Xenon burner D2S (Messrs Philips for headlamps with projection system)	As required