Retrofit wiring harness - AZ82.70-P-0001-04M

Prepare wiring harness as shown in figure.

Fig 1: Wiring Harness Diagram
Connect blue fuse block (F) according to figure to rear SAM control unit (N10/8).
The fuse carrier has to be equipped with a 7.5 A fuse.

Fig 2: Identifying Blue Fuse Block And SAM Control Unit
Connect the brown line of the adapter line (2) to the CAN ground shielding and rear SAM (W50/2).

Fig 3: Identifying Adapter Line And Rear SAM
Strap down the connection line (1) according to figure and route to the transmission tunnel.
Fasten adapter line (2) to existing lines using tie straps.
Fasten strapped down white coupling (4) also (not required).

Fig 4: Identifying Adapter Line And Connection Line
Fasten black coupling of video systems (5) under the seat using self-adhesive felt (arrow) according to figure.

Fig 5: Identifying Coupling Of Video Systems And Self-Adhesive