Remove/install inner tie rod with axial joint - AR46.40-P-0201GH

MODEL 163.113 /128 /136 /154 /157 /172 /174 /175 

Fig 1: Identifying Inner Tie Rod With Axial Joint Components (1 Of 3)

Fig 2: Identifying Inner Tie Rod With Axial Joint Components (2 Of 3)

Fig 3: Identifying Inner Tie Rod With Axial Joint Components (3 Of 3)

	Remove/install
1	Remove tie rod		AR46.40-P-0200GH
2	Remove bellows	If the right-hand inner tie rod with axial joint (12b) is removed, the left-hand bellows must also be removed.	AR46.40-P-0400GH
3	Toothed rack with open-end wrench attachment Counterhold 24 mm (arrow) or corresponding open end wrench	The surface for counterholding at the toothed rack is only located on the left-hand side.
4	Detach inner tie rod with axial joint (12a or 12b); to do this, use 36 mm or 38 mm open-end wrench attachment (012)	Do not use force (hammer blows, excessive leverage) otherwise you may damage the steering gear.
		Torque wrench	Fig 4
		Open-end wrench	Fig 5
		Open-end wrench	Fig 6
			*BA46.40-P-1003-01C
5	Install in the reverse order

Tie rod

Number	Designation		Model 163
BA46.40-P-1003-01C	Inner track rod with axial joint to rack-and- pinion joint	Nm	110

Fig 4: Identifying Torque Wrench (001 589 67 21 00)

Fig 5: Identifying Open End Wrench (220 589 01 01 00)

Fig 6: Identifying Open End Wrench (220 589 02 01 00)