Deployment of emergency tensioning retractor units when no deployment device is present - AR91.40-P-0611-05A

AR91.40-P-0611-05A	Deployment of emergency tensioning retractor units when no deployment device is present
	Risk of injury  caused by performing testing or repair work on airbag or emergency tensioning retractor units.	Model 163, 168, 170, 202 as of 1.7.93, 203, 208, 209, 210, 215, 220, 230, 414, 463	AS91.00-Z-0001-01A
		Store airbag units with the discharge opening facing upwards, do not subject to temperatures exceeding 100 °C, interrupt any current supply to the units prior to working on them
	Risk of injury  caused by performing testing or repair work on airbag or emergency tensioning retractor units.	Model 202 up to 30.6.93 Store airbag units with discharge opening facing upwards, do not subject to temperatures exceeding 100 °C, interrupt any current supply to the units prior to working on them, and unplug test connector/plug connector from airbag (AB) with emergency tensioning retractor (X11/13)	AS91.00-Z-0001-01B
	Notes on controlled deployment of airbag, sidebag and emergency tensioning retractor units	With model 163, 168, 170, 202, 203, 209, 208, 210, 215, 220, 230, 414, 463	AH91.60-P-0611-02P
	Ignition cable for firing airbag and seat belt tensioner units		WF58.50-P-9160-02A
	Notes on disposing of airbag and emergency tensioning retractor units	All models	OS91.00-P-0001-01A

Application of shop-made ignition cables 

1. Fabricate ignition cables at least 10 m long with a pressure switch at the end.
2. Plug the 2-pin plug into the corresponding emergency tensioning retractor unit.
3. Connect ignition cables to the battery.
4. Press both pressure switches simultaneously.

   Keep a distance of 10 m for safety.