Connect hand-held tester (HHT), read out diagnostic trouble code memory - AD00.00-P-2000-03C
Model 163 up to 31.08.01
Model 168
Commercially available tools
| Number | Designation | |
|---|---|---|
| WH58.30-Z-1036-13A | Handheld tester (HHT) | 651 100 01 99 |
| WH58.30-Z-1037-13A | Test cable (multiplexer) | 651 100 40 99 |
| WH58.30-Z-1044-13A | Adapter cable (HHT) for datalink connector (X11/4, 16-pin) | |
- Connect hand-held tester (087) to diagnosis test connector (X11/4) in interior using test cable (multiplexer) (094) and adapter cable (107).
- Switch on ignition.
- According to instructions in display:
- Read out/erase fault memory
- Read out actual values
- Perform actuations
- Program control modules
- Disconnect HHT.
Note system-specific deviations listed in respective diagnosis description in chapter entitled "Diagnosis Previous Knowledge".
Stored faults possibly caused by cables being disconnected during testing or by simulation must be erased from the fault memory once the work is completed.