Solenoid valve 1-2/4-5 for shift mechanism -fault code description ME - AD07.61-P-4000-38L

		Solenoid valve 1-2 / 42/4-5 shift mechanism
1	Fault code ( Readout on generic scan tool)	P205F (P0753)
2	Fault storage	After expiry of test duration and fault
2	Actuation of the indicator lamp Engine diagnosis (EURO3/4) CHECK ENGINE (MIL) malfunction indicator lamp	No activation Following two successive driving cycles with faults
3	Checking frequency	Continuous
4	Checked signal or status	Actuation of control solenoid valve, shift pressure.
5	Fault setting conditions	Fault if the voltage is less than 0.4 volts.
	Short circuit to ground	Approx. 8.5 V
	Lower limit value for voltage	Approx. 15 V
	Upper limit value for voltage	Approx. 0.3 A
	Lower limit value for current	Approx. 0.7 A
	Upper limit value for current	Approx. 1 second
	Checking duration
6		Faults (actuation line discontinuity or short circuit, short circuit in valve) are recognized by the EGS control unit and reported to the ME control unit via the CAN data bus. Storage of faults and actuation of the CHECK ENGINE indicator lamp (MIL) are undertaken by the ME control unit. Also read out the EGS fault memory.