Pulse width modulation solenoid valve for torque converter lockup - fault code description ME - AD07.61-P-4000-35L

		Pulse width modulation solenoid valve for torque converter lockup
1	Fault code ( Readout on generic scan tool)	P2062 (P0743)
2	Fault storage	After expiry of test duration and fault
	Actuation of the indicator lamp Engine diagnosis (EURO3/4) CHECK ENGINE (MIL)	No activation Following two successive driving cycles with faults
3	Checking frequency	Continuous
4	Checked signal or status	Duty cycle for actuation of pulse width modulation solenoid valve
5	Fault setting conditions	Duty cycle less than 5%
	Lower limit value	Duty cycle great than 94%
	Upper limit value
6		Faults (line discontinuity and short circuit) are detected by the EGS control unit and reported to the ME control unit via the CAN data bus. Storage of faults and actuation of the CHECK ENGINE indicator lamp (MIL) are undertaken by the ME control unit. Also read out the EGS fault memory.