Pressure sensor ME-SFI - fault code description - AD07.61-P-4000-02L

		Intake manifold pressure sensor
1A	Fault code ( Readout on generic scan tool)	P2007 (P0105)
1B	Engines 112, 113 as of 1/01	P2007-[1 ] Short-circuit to positive (P0105)
	Fault code ( Readout on generic scan tool)	P2007-[2] Short circuit to ground/line discontinuity (P0105)
2	Fault storage	after expiry of test duration and fault
	Actuation of the engine diagnosis indicator lamp (EURO3/4) or CHECK ENGINE (MIL) malfunction indicator lamp	following two successive driving cycles with faults
3	Checking frequency	Continuous
4	Checked signal or status	Limits for pressure sensor signal (intake manifold absolute pressure)
5	Fault setting conditions  Lower limit value Upper limit value Order of magnitude of the intake manifold pressure Checking duration	At an engine speed of 500 to 1300 rpm the vacuum must be greater than 30 to 60 mbar. At a throttle flap angle greater tan about 60° the vacuum must be greater than 300 mbar. Vacuum of 500 to 1200 mbar; depending on performance map for motor speed and throttle flap angle. About 5 seconds per limit value
6	Check prerequisites	locking time after start of about 20 seconds expired no fault in the throttle flap angle after starting the engine increase engine speed at least once to over 1300 rpm.