Intake air temperature sensor ME-SFI - fault code description - AD07.61-P-4000-03L
| Intake air temperature sensor | ||
|---|---|---|
| 1A | Fault code ( |
P2006 (P0110) |
| 1B | Engines 112, 113 as of 1/01 | P2006-[1] Short-circuit to positive (P0110) |
| Fault code ( |
P2006-[2] Short circuit to ground/line discontinuity (P0110) | |
| 2 | Fault storage | after expiry of test duration and fault |
| Actuation of the engine diagnosis indicator lamp (EURO3/4) or CHECK ENGINE (MIL) malfunction indicator lamp |
following two successive driving cycles with faults | |
| 3 | Checking frequency | Continuous |
| 4 | Checked signal or status | Limits for intake air temperature |
| 5 | Fault setting conditions | Fault if signal is less than 0.1 V (corresponds to approx. 300 kΩ and approx. -50°C). |
| Lower limit value Upper limit value Checking duration |
Fault if signal is greater than 4.93 V (corresponds to approx. 92 Ω and approx. +150°C). approx. 1 second | |
| 6 | If a fault exists, vehicle continues operating with substitute value + 20°C. The system will then change back over to the signal from the intake air temperature sensor once the signal becomes plausible again. |