Camshaft Hall sensor - fault code description ME - AD07.61-P-4000-14AA

			Camshaft Hall sensor
1	Fault code ( Readout on generic scan tool)		P201A (P0341)
2	Fault storage		after expiry of test duration and fault
	Actuation of the engine diagnosis indicator lamp (EURO3/4) or CHECK ENGINE (MIL) malfunction indicator lamp		following two successive driving cycles with faults
3	Checking frequency		Continuous
4	Checked signal or status		Camshaft Hall sensor signal
5	Plausibility		The signal must change from 0 to 1 and from 1 to 0 within 2 engine revolutions,
		No signal Quantity	Max. of 1 signal change per engine rotation
6	Check prerequisites		engine speed 25 to 6000 rpm no fault in crankshaft position sensor
7			If the signal from the camshaft Hall sensor is missing or if false synchronization is recognized, fuel cutoff will occur to avoid damaging the TWC.