CAN fault detection ME - fault code description - AD07.61-P-4000-32LF

1	Fault code ( Readout on generic scan tool)	P2030 CAN message from electronic selector lever module control unit (N15/5) missing or faulty (P0600)
2	Fault storage	After expiry of test duration and fault
	Actuation of the indicator lamp Engine diagnosis (EURO4) CHECK ENGINE (MIL)	No activation Following two successive driving cycles with faults
3	Checking frequency	Continuous
4	Checked signal or status	The selection lever position is detected by the selector lever module on the center shifter console for the engine control unit and transmitted via the CAN.
	Checking duration	Approx. 10 seconds