CAN fault detection ME - fault code description - AD07.61-P-4000-32LE

1	Fault code ( Readout on generic scan tool)	P2037 CAN message from EGS control unit(N15/3) missing or faulty (P0600)
2	Fault storage	After expiry of test duration and fault
2	Actuation of the indicator lamp Engine diagnosis (EURO3/4) CHECK ENGINE (MIL)	No activation Following two successive driving cycles with faults
3	Checking frequency	Continuous
4	Checked signal or status	The information motor speed, accelerator pedal position, engine torque, switching point alteration (e.g. due to TWC heating), the engaged gear, variant coding or any faults on the transmission which could negatively effect exhaust quality is exchanged between the engine control unit and EGS control unit. This communication is monitored.
4	Checking duration	Approx. 10 seconds