Sliding/Pop-Up Sun Roof

Slide inside cover to open position. Place roof panel in tilted position. Pull retaining lip for left rubber seal out of groove at bottom of sliding/pop-up sun roof. Unclip clip located on front of left rubber fold seal on tilting bracket. Turn rubber fold seal with plastic rail toward center of vehicle and until clip at rear of sliding/pop-up sun roof frame releases. Remove left rubber fold seal. Repeat procedure for right rubber seal.

Close sliding/pop-up sun roof. Loosen 2 screws on each side of roof panel. Adjust front of roof panel so panel is 0-.039" (0-1 mm) lower than roof. Adjust rear of roof panel so panel is 0-.039" (0-1 mm) higher than roof. Take these measurements in 4 positions 5.5" (140 mm) in from corner of opening for sliding roof panel. After adjustment, install rubber seal on slider.