Removing and installing exterior door handle on rear door - AR72.12-P-2410GH

MODEL 163 

Fig 1: Identifying Rear Exterior Door Handle Components

	Removal, installation
1	Loosen screw (3)	Accessible through opening (8) in end of door, loosen screw (3) max. 5 turns
			*BA72.12-P-1002-01C
		Torx bit set	Figure
2	Remove guide (2)
3	Pull handle (1) toward rear together with base (4) out of bearing bracket (6) and remove
4	Remove base (5)
5.1	Remove bearing bracket (6)	Only if bearing bracket is defective. The bearing bracket (8) can only be removed through the installation opening in the inner door panel. For this purpose ↓
		Remove door liner on rear door	AR72.12-P-1010GH
6	Install in opposite order
7	Check for proper function

Rear door

Number	Designation		Model 163
BA72.12-P-1002-01C	Screw for door handle	Nm	1.5

Fig 2: Identifying Torx Bit Set (00 589 01 10 00)