Remove/install tailgate handle molding - AR72.20-P-3650GH

MODEL 163.113 /128 /136 /154 /157 /172 /174 /175 

Fig 1: Identifying Tailgate Handle Molding Components

	Remove/install
1	Remove liner on tailgate	Do not remove upper section of door liner (omit steps 11 - 13).	AR72.20-P-3520GH
2	Unscrew nuts (2) on handle strip (1) from inside of tailgate	From the door inside.
3	Disconnect connector from the license plate lamp, rear-end door on left (E19/3) or license plate lamp, rear-end door on right (E19/4)
4	Unscrew screws (3) on handle strip (1)	From door outer side.
5	Remove handle strip (1)	Risk of breakage. Do not scratch paint
6	Install in the reverse order