Removing and installing luggage compartment floor covering - AR68.20-P-4810GH

MODEL 163.113 /128 /136 /154 /157 /172 /174 /175 

Fig 1: Identifying Luggage Compartment Floor Covering Components

	Remove/install
	Torx bit set		Figure
1.1	Remove inner spare wheel together with cover	Only model 163.174.	AR68.30-P-4610GH
2.1	Fold third seat row upward	Only with 3rd seat row, code 847. See owner's manual
3	Remove load compartment floor flaps	See owner's manual
4.1	Remove seat belt end fitting for third seat row (1)	Only with 3rd seat row, code 847.
			*BA91.40-P-1001-01D
5	Unscrew screws for load retainer (2)		*BA68.50-P-1001-02A
6.1	Remove mount for child seat retainer	If installed
			*BA91.20-P-1001-01A
7	Remove cover for rear edge of load compartment	Do not scratch cover when removing caps. Installation:  Properly install seal on rear-end door.
8	Remove floor covering (3) to rear	Installation:  Install floor covering below side paneling.
		Assembly wedge	Fig 2
9	Install in the reverse order

Safety belts/emergency tensioning retractors

Number	Designation		Model 163 up to 08/99	Model 163 as of 09/99
BA91.40-P-1001-01D	Belt end fitting screw	Nm	35	35

Luggage nets

Number	Designation		Model Series 163
BA68.50-P-1001-02A	Bolt securing cargo retainer bracket to loading compartment floor	Nm	24

Child seats

Number	Designation		Model Series 163
BA91.20-P-1001-01A	Bracket for child seat anchorage on load compartment floor	Nm	24

Fig 2: Identifying Assembly Wedge (110 589 03 59 00)

Fig 3: Identifying Torx Bit Set (000 589 01 10 00)