Remove brush guard - AR88.30-P-2000-01GH
Modification notes
| 10.8.01 | Value modified from 25 Nm to 49 Nm | Value modified in BA88.30-P-1003-01A for model 163 up to 31.8.01 | *BA88.30-P-1003-01A |
| Number | Designation | Model 163 up to 31.8.01 | |
|---|---|---|---|
| BA88.30-P-1002-01A | Nut, spacer tube on brush guard | Nm | 86 |
| BA88.30-P-1003-01A | Screw, mount on brush guard | Nm | 49 |
| BA88.30-P-1011-01A | Bolt, underride guard to brush guard | Nm | 25 |
| BA88.30-P-1015-01A | Nut, underride guard to bracket | Nm | 49 |
| BA88.30-P-1016-01A | Bolt, front section of underride guard to rear section of underride guard | Nm | 49 |
- Remove screws (1) and nuts(2)from underride guard (3) at bottom of vehicle
- Remove screw for brush guard (4) from inner mount at bottom (5)
- Remove nut for spacer tube (6)
- Remove spacer sleeve (7) from spacer tube nut (6).
- Remove brush guard (8) toward front.
Carefully move out brush guard so that paint is not damaged.
Only if available.