Prepare cutting tool - AR88.30-P-0200-04GH

Observe general notes, guidelines and safety precautions for operation of pneumatic tools contained in the operating instructions, included with the tool kit to avoid hazards and incorrect operation.

Sharpen blades before use and while cutting with wet whetstone WK8 to obtain best results. Detach detachable components from front fender, rear fender and tailgate with the following blades:

• Blade WK24ZV (5) with adjustment arm WK11B (6) when using pneumatic tool WK1 0HD (3).
• Blade WK24S (1) or WK6 with handle WK7 (2) for manual use.

Fig 1: Identifying Cutting Tool Blade With Adjustment Arm

1. Attach felt pads (4) at the bottom of the pneumatic tool (vehicle side) as well as the back of the blade to protect the paint work.
2. Adjust cutting depth with adjustment arm WK11B (6).

   To separate the detachable components from the front fender and rear fender, adjust rear adjustment arm WK11 to a=25 mm, on tailgate to a=40 mm.

   Fig 2: Identifying Cutting Tool Adjustment Components & Measurements

   
3. Set compressed air valve to p=6 bar for operation of pneumatic tool and turn power control on tool to position 1/2 - 2/3.