Performing software download - AF82.85-P-6000-04A

COMAND 2.0-ECE / 2.5-ECE - Perform software download of CD: 

Do not start vehicle during download, do not cause other voltage drops in the vehicle electrical system, do not remove CD and do not switch off unit! (Unit will be damaged!)

In the case of erroneous operation of the download control module, the download starts again or is terminated if the old software has not been erased previously.

1. Switch off ignition.
2. Remove navigation CD and insert download CD.
3. Switch off control module.
4. After a waiting time of min. 5 s and with buttons * and # pressed simultaneously, switch on unit.

   The menu "Service download of CD" appears with menu points "Control module" and "Termination".

5. Select "Start control module" with right knob

   The date or the version of the currently stored software and the software on the CD appears in the display.

   By pressing the right knob the download is started. After some seconds the system changes to screen "CD ROM software download".

   • On the download control module the main processor software is loaded first, then the graphic processor software. Entire duration: approx. 40 minutes
   • The download progress is indicated by a bar graph.

   In the event of errors an error message is indicated on the display.

   When the download is completed, the display switches off for a short time. When it is switched back on again the result of the download is displayed.

6. Remove download CD and reinsert navigation CD.