Retrofit wiring harness - AZ82.70-P-0001-04D

Model 163 as of 1.12.99 up to 31.8.00 for Nokia 3110 portable CTEL 

1. Shop-make wiring harness as specified in steps 2 to  6.
2. Cut cables at connection adapter (20) to length of approx. 150 mm.
3. Install terminal (22) on five free lead ends of connection adapter (20) (not to green lead).
4. Release catch (arrows) at connector (21) one detent.
5. Insert terminal of red (rt) lead into chamber 3

   Terminal of yellow (ge) lead into chamber 2

   Terminal of black (sw) lead into chamber 4

   Terminal of blue (bl) lead into chamber 5

   Insulate terminal of green (gn) lead and tie back (not required).

   Fig 1: Identifying Lock Connector And Terminals

   
6. Lock connector (21).
7. Connect prefabricated wiring harness (8) to adapter wiring harness (9).
8. Check fuse (23) (a 10A fuse should be present).
   Fig 2: Identifying Adapter Wiring Harness And Fuse

   
9. Connect adapter wiring harness (9) to radio wiring harness.
10. Connect microphone cable and loudspeaker cable to hands-free unit (3).
11. Plug in connection cable (2) and fit on cover (6).
12. Connect prefabricated wiring harness (8) to connector (24) for hands-free system.
    Fig 3: Identifying Adapter Wiring Harness And Hands-Free Unit

    
13. Attach hands-free unit (3) with assembly base (4) to mount of hands-free unit (20).

    Speaker mount (21) is attached to the assembly base.

14. Route pre-assembled hands-free system into the area at the back to the AC operating unit.
    Fig 4: Identifying Hands-Free Unit And Assembly Base