Retrofit video player - AZ82.60-P-0004-05A

Model 163.136 /154 /172 #A as of 145273, Models 163.136 /154 /172 #X as of 708319, Models 163.113/128 /157 /174 /175

Rear seats

Number	Designation		Model 163 as of 09/99
BA91.12-P-1005-03A	Nuts for rear seat console on vehicle floor	NM	40
BA91.12-P-1008-03A	Screws for rear seat console on vehicle floor	NM	40

Unscrew rear nut (1) and bolt (2) from 60% rear seat.
Position bracket (3)and secure with bolt (2) and nut (1) .
Insert bolt with Loctite. Replace nut.
Install covers under the 60% rear bench.
Replace center cover at rear seat bench at bottom with cover from the conversion kit. Do NOT install shade at front at the 60% bench.

Fig 1: Identifying Rear Seat Bracket
Apply transparent protective foil in area of locking arm (5) of video/DVD player to crossmember of seat frame (4).
Slide video/DVD player (6) into bracket under the 60% rear seat.
Ensure that the guide on the underside of the playback unit is moved into the V-shaped cutout in the bracket.
Fold locking arm (5) above seat frame crossmember (4).
Install striker (7) for seat adjustment.
Before installation ensure that the seat is completely to the rear because after installation adjustment is no longer possible. Striker should be installed approximately 5 mm to the left of the video player, with the flat side facing the video player.
Insert corresponding plug, video or DVD, into the playback unit.

Fig 2: Identifying Video/DVD Player, Striker And Locking Arm