Cover fiber optic cable - AR82.95-P-0005-01A
Do not remove protective covers too early from the fiber optic cable coupling (3) or the device connection (4) because contaminated or scratched surfaces may absorb the light. Fiber optic cables must not be kinked, routed over sharp edges or bent in radii of less than 25 mm, otherwise the fiber optic cable core will be yellowed and broken. Yellowed or broken fiber optic cables weaken the light.
The work procedure is shown on components of the digital data bus (D2B).
- Carefully detach the fiber optic cable coupling (3) from the device connection (4) and cover it with a protective cap (1), stop plug (2) or a clean rag.
The protective cap (1) and stop plug (2) for the digital data bus (D2B) components are not separately available. The protective caps (1) and plugs (2) of installed replacement parts must be used. The components of the Media Oriented System Transport (MOST) must be covered up with clean rags, as generally they are not fitted with protective caps (1) and plugs (2).