Retrofitting telephone console - AZ82.70-P-0001-01A

Model 163 up to 31.8.00 for Nokia 3110 portable CTEL 

1. Place assembly plate (10) onto telephone console (12) as shown in figure and align to size: a=20 mm and b=55 mm. Mark hole pattern and drill with 2.5 dia. bit.
2. Attach assembly plate (10) to telephone console (12) with screws (11).
   Fig 1: Identifying Telephone Console And Assembly Plate

   
3. Plug connection cable into mount and route to the rear in a curve (arrow) as shown in figure.
   Fig 2: Plugging Connection Cable Into Mount

   
4. Fasten mount (1) to assembly plate (10) with locating screw (16).
   Fig 3: Identifying Fasten Mount And Assembly Plate

   
5. Install holder (1) on telephone console (12) and stick the antenna lead (17) as well as the connection cable (2) into the console with felt (arrows).
   Fig 4: Identifying Holder And Telephone Console

   
6. Push telephone console below wood trim cover (arrows) and press against right tunnel wall.
7. Mark hole for screw (13) and drill with Ø 5 mm.

   When drilling pull tunnel wall outward slightly so that parts behind cannot be damaged.

8. Install clip nut (14) on tunnel wall and install screw (13).
9. Connect antenna cable (17) to vehicle antenna cable.
10. Push connection cable (2) and antenna cable (17) below tunnel wall, route along existing wiring to radio slot and stick the connector of the antenna cable tight with felt.
    Fig 5: Pushing Connection Cable