LEMON Manuals: Even more car manuals for everyone
Home >> Mercedes Benz >> 2000 >> ML430 >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Mirrors >> Detachable Body Components -- 163 Chassis >> Testing & Repair >> Remove/install release handle for exterior spare wheel mount - AR88.30-P-1001-01GH

Remove/install release handle for exterior spare wheel mount - AR88.30-P-1001-01GH

Fig 1: Identifying Assembly Wedge (110 589 03 59 00)
G04609121

    Removal: 

  1. Press housing (1) out of spare wheel mount/spare wheel (2) with assembly wedge.
  2. Turn release handle (3) clockwise to 3 o'clock position.
  3. Remove release handle and housing.

    IMPORTANT Guide release handle past release lever on inside of spare wheel mount/spare wheel.

    Fig 2: Identifying Spare Wheel Mount Handle And Housing (1 Of 2)
    G04609122
    Fig 3: Identifying Spare Wheel Mount Handle And Housing (2 Of 2)
    G04609123

    4. Installation: 

  4. Assemble housing (1) and insert release handle (3) into housing (1) in 3 o'clock position.
    5. Fig 4: Identifying Housing And Handle
    G04609124
  5. Insert release handle with housing into spare wheel mount/spare wheel.

    IMPORTANT Opening in housing should point downward. Position housing at bottom first.

  6. Turn release handle counterclockwise upward to vertical position.

    IMPORTANT Guide release handle below release lever on inside of spare wheel mount/spare wheel.

  7. Position release handle with housing further to rear in spare wheel mount/spare wheel.

    IMPORTANT Do not yet allow housing to arrest in spare wheel mount/spare wheel. Ensure that release handle is positioned properly in recess on rear of lock.

  8. Check release function of lock with release handle.
  9. Insert housing completely into spare wheel mount/spare wheel until it catches.
    Fig 5: Identifying Release Handle With Housing Further To Rear In Spare Wheel Mount/Spare Wheel
    G04609125
scientia non olet · About LEMON Manuals